What does Flachdach Abdichtung in Aargau typically involve?

Preparation (protection, cleaning, joint cutting), material‑appropriate sealing, controlled tooling and final inspection with handover.

Which materials do you use?

Depending on substrate and use case: sanitary silicone, MS polymer, acrylic or system solutions. Adhesion, movement and resistance are decisive.

How long does the work take?

It depends on scope and access. Small joint jobs are often completed within a few hours; larger refurbishments are planned in stages.

Which standards and manufacturer specs do you follow?

We follow SIA/EN guidelines and system supplier specifications—e.g., movement capability, joint dimensions, pretreatment and curing times.

0 results

Flachdach Abdichtung – Zug

Flachdach Abdichtung in Aargau – standards‑aligned and durable.

Eurofugen – Flachdach Abdichtung in Aargau. We define joint width/depth, bond zones and the correct backer rod. We follow SIA/EN guidelines and manufacturer specifications.

Typical use cases: Roof connections, flat roof details, penetrations and joints. Material selection by substrate, movement and load—incl. primer and backer rod. With clear care tips so joints stay in good condition for a long time.

Scope of work

Assessment & short consultation
Removal of old material (where needed)
Cleaning/degreasing the substrate
Primer/backer rod (if required)
Apply sealant & tool cleanly
Final check + care tips

Planning & preparation

We clean/degrease substrates, define edges and limit bond areas. Primers and backer rods are selected to match substrate, movement and joint width. For critical details, mock‑ups and simple adhesion checks secure approval.

Application & control

We apply sealant bubble‑free, fill the joint completely and tool it evenly. Masking is removed in time; transitions are reworked cleanly and edge adhesion is checked. Photo/measurement logs on request.

Frequently asked questions (Flachdach Abdichtung)

What does Flachdach Abdichtung in Aargau typically involve?

Preparation (protection, cleaning, joint cutting), material‑appropriate sealing, controlled tooling and final inspection with handover.
Which materials do you use?

Depending on substrate and use case: sanitary silicone, MS polymer, acrylic or system solutions. Adhesion, movement and resistance are decisive.
How long does the work take?

It depends on scope and access. Small joint jobs are often completed within a few hours; larger refurbishments are planned in stages.
Which standards and manufacturer specs do you follow?

We follow SIA/EN guidelines and system supplier specifications—e.g., movement capability, joint dimensions, pretreatment and curing times.